On-Line Basic Operating Instructions

A.  Knobs ( 2 ) used to secure the
        metal & wax practice pins

 B.  Metal (Practice) Milling Pin

 C.  Lever secures the Intra - Mill to
        the surveyors spindle

 D.  Governor used to regulate the
        maximum speed

 E.  The Intra - Mill motor

 F.  The Intra - Mill body

 G.  Rotary cutting tool

 H.  Wax (Practice) Milling Pin

  I.  The Intra - Model secures the
        metal & wax Milling Pins

Remove undercut lock device located on bottom of surveyors spindle.  The device can be placed in storage area under the cap on surveyor. 

Attach main body (F) on to surveyor spindle, securely lock it using lever (C), adjust to desired height and lock in place using surveyors spindle lock knob. 

With air pressure off loosen screw on in-line oiler fill with  air- motor-oil (a needle is provided for this) re-insert and tighten screw. 

When mounting the Intra-Model (I) on surveyors model holder the rounded end faces the movable jaw, the rubber cushion surface faces the two stationary jaws side.   

Milling Procedures

  Before operating  this machine use all safety precautions and good common sense

Observe All Warning and Precautions

When inserting a bur/cutting tool into the motor, be certain that it is inserted all the way into the collet.  There should be a minimal amount of extension of the cutting tool shank.  Excess amount of extension of the cutting tool shank can be dangerous, especially high speeds. 

Using the provided wrenchs, tighten collet sufficiently.  Rotate motor spindle by hand to confirm that the cutting tool is turning straight. (I.E., Centric).  If not, repeat procedure until the bur/cutting tool etc. turns straight and true. Be certain the cutting tool is appropriate and in good condition. 

(See accompanying safety instructions). 

 

INSTALLATION / MAINTENANCE (SAFETY) 

 

Familiarize your self with the features and functions of various aspects and components of the unit.  (See diagram).

CAUTIONBe sure that the lubricator unit has sufficient oil and no more than 90 LB per sq. inch air pressure is used.

(Use FERRARO turbine oil).

Replace any damaged, worn or improperly functioning parts.

 

SPECIAL SAFETY INSTRUCTIONS:  

 

Remember: Use Approved Safety Goggles, Dust Mask and Dust Collecting System, this applies to the user and all persons in the area.

Replace any damaged, worn or improperly functioning parts.

When inserting a bur/cutting tool into the motor, be certain that it is inserted all the way into the collet.  There should be a minimal amount of extension of the cutting tool shank.  Excess amount of extension of the cutting tool shank can be dangerous, especially high speeds. 

Using the provided wrenchs, tighten collet sufficiently.  Rotate motor spindle by hand to confirm that the cutting tool is turning straight. (I.E., Centric).  If not, repeat procedure until the bur/cutting tool etc. turns straight and true. Be certain the cutting tool is appropriate and in good condition. 

Never run motor at high speed without a load on it.  (I.E., without milling-drilling etc.)  
Familiarize yourself with the features and functions of various aspects and components of the unit.  (See diagram).

Replace any damaged, worn or improperly functioning parts.

 

Always heed all safety precautions

 

Observe:  Before operating use all safety precautions and good common sense

Always heed all safety precautions!

Please visit this page often for the latest additions

 

 

 

 

 

 

 

01/29/06