MX-7 Electric
Dental Milling Machine

As pictured above

List Price   $3750.00  U.S. Currency

To see diagram of MX-7 (Electric) click on this link or photo

To see full page photo click this link

 Manufactured and serviced in the USA.                 
 

Slow speed internet connection

High speed internet connection

The MX-7 "Electric" is our best selling

Milling Machine

Work Of Art

Art That Works

Now with enhanced
Stent/Surgical Template drilling capacity

In accordance with our engineering concept of manufacturing equipment that can be upgraded, we are pleased to introduce the MX-7 which is the first major upgrade of our MX-5 that was introduced in 1994.

We have re-engineered and added a split arm that enhances the overall fluid movement of the Motor-Arm i.e., there is one additional pivot point. The jointed articulated design also significantly assists in the.

1.  Positioning of the Motor/Cutting-Tool over the area to be milled.

2. Alignment of the arms at an ideal angle that  facilitates fluid graceful movement (no dead spots that double jointed machines may have).

 3. Rapid Setting/Adjusting the vertical height of the motor/arm.

 NOW with two (right & left) triple jointed Hand- Rests that support and track your motor movement. 

The primary reason to select the Electric Motor MX-7 would be "brute power", our Electric Motor has the power to mill cases that require extensive metal removal i.e., Implant/Denture bars, etc. Our electric motor has high torque from 5,000 to 20,000 RPM.

Additionally with the ever increasing use of implants comes a need to drill precision holes in predetermined locations at exacting angles in Stents & Surgical Templates.

The MX-7 (Electric) features a powerful motor that produces high torque at low RPM that prevents the plastic (stent /surgical template) from overheating and causing inaccurate hole size. The motor comes with collets that allow it to accept friction grip, lab-handpiece, 3mm, and  Ferraro burs (collets provide greater accuracy than 3 jaw chuck).

 Additional reasons would be the ease that you can perform "On the fly milling" i.e., raising and lowering the motor/bur as you are milling side to side, facilitating simultaneous vertical/horizontal milling, this allows you to mill a shelf/shoulder that follows the contour of the gum line.

The Air and Electric motor arm assembly  are interchangeable and can be purchased separate, allowing the user to switch between the two.

Owners of the MX-5 can have their Milling Machines upgraded to the MX-7 (direct from us only)  

The MX-7 can be up-graded with the same accessories as the Da Vinci or Omega.

The MX-7 shown above has the Precision X-Y Table installed.

Up-grading to dual milling mode allow traditional milling on the master model or with the Round Surveyor Table installed, "Analogue (transfer) Model Milling".

Link to Da Vinci accessories

Dual Articulated hand - rest allow your hand to remain supported as you track the movement of the motor (handpiece). 

Link for on-line Operating Instructions