On-Line Basic Operating Instructions

A.  Collet /Assembly   B.  Lever to Lock/Loosen Handpiece   C.  Depth Stop Collar / Locking Thumbscrew   D.  Motor Governor   E.  Set Screws  to Adjust Motor Arm Height   F.  Surveyor Spindle   G.  Clamping Arm Lever (Surveyor Spindle)   H.   Locking Thumb Screw  (Not Shown)  Locks Surveyor Spindle       Not shown:  Filter/Regulator/Lubricator, Footpedal

INSTALLATION OF Mill&Drill ATTACHMENT: 

     1.  Loosen Knob/lever (G).  Spread two halves of surveyor clamp, (upper clamping arm) slip onto surveyor's spindle.  Tighten Knob/lever. 
2.   Loosen both 1/8”set screws (E) on upper clamping arm Raise or lower spindle (C) to desired height, tighten set screws.

INSTALLATION / MAINTENANCE (SAFETY) 

Be sure that your air source is off and there is no pressure in your air line.
Connect filter/regulator/lubricator to your air line.  Connect foot pedal to filter/regulator/lubricator.  Using the quick connector, couple your foot pedal to the air motor. 

Familiarize your self with the features and functions of various aspects and components of the unit.  (See diagram).

Using the regulator, reduce pressure to zero before adding oil to the lubricator.

CAUTION:  Be sure that the lubricator unit has sufficient oil and no more than 90 LB per sq. inch air pressure is used.. 

(Use FERRARO turbine oil).

Replace any damaged, worn or improperly functioning parts.

Using the regulator, reduce pressure to zero before adding oil to the lubricator.

SPECIAL SAFETY INSTRUCTIONS:  

Remember: Use Approved Safety Goggles, Dust Mask and Dust Collecting System, this applies to the user and all persons in the area.

Replace any damaged, worn or improperly functioning parts.

When inserting a bur/cutting tool into the motor, be certain that it is inserted all the way into the collet.  There should be a minimal amount of extension of the cutting tool shank.  Excess amount of extension of the cutting tool shank can be dangerous, especially high speeds. 

Using the provided wrenchs, tighten collet sufficiently.  Rotate motor spindle by hand to confirm that the cutting tool is turning straight. (I.E., Centric).  If not, repeat procedure until the bur/cutting tool etc. turns straight and true. Be certain the cutting tool is appropriate and in good condition. 

Never run motor at high speed without a load on it.  (I.E., without milling-drilling etc.)  
Familiarize yourself with the features and functions of various aspects and components of the unit.  (See diagram).

Replace any damaged, worn or improperly functioning parts.

Always heed all safety precautions! 

Observe:  Before operating use all safety precautions and good common sense

Always heed all safety precautions!

Please visit this page often for the latest additions

01/29/06