On-Line Basic Operating Instructions

A.  Adjustable lever used to lock saw body at desired angle. If levers position (after locking) is undesirable, pull lever towards you reposition and release lever.   B.  Backbone of saw frame.   C.  Adjustable saw blade holder with (black anti-rotation pin, not shown in photo).   D.  Knob used to tighten saw blade.   E.  Stationary saw blade holder.   F.  Saw frame in horizontal position.

Caution always use approved safety eye protection, dust mask and dust collection system.

 Before operating  this machine use all safety precautions and good common sense

Observe All Warning and Precautions

To change blade, loosen knob (D) while holding (black pin (C) not shown) until old blade can be removed.

Insert new blade in vertical slot (E) be sure blades pin is in horizontal slot.

Insert other end of blade in adjustable blade holder (C), while holding black anti-rotation pin tighten knob (D). Caution over tightening can cause blade to snap.

To reposition saw, loosen lever (A), adjust saw frame to desired angle and retighten (A).

When sawing in the vertical position it is recommended that the teeth of the blade point in the direction of the stationary saw blade holder (E).

SPECIAL SAFETY INSTRUCTIONS: 

Remember: Use Approved Safety Goggles, Dust Mask and Dust Collecting System, this applies to the user and all persons in the area.

01/29/06